Table of Contents
Advertisement
Controls
>
Combination Switch
1 Low beam (with lighting switch
turned clockwise two notches)
2 High beam (with lighting switch
turned clockwise two notches)
3 High beam flasher (high beam
available independent of lighting
switch position)
4 Turn signals, right
5 Turn signals, left
26
To operate the turn signals, move the
combination switch past the point of
resistance (up or down). The switch is
automatically cancelled when the
steering wheel is turned by a large
enough angle.
To signal minor directional changes of
the vehicle, such as changing lanes
on a highway, move combination
switch to the point of resistance only
and hold it there.
6 Control for windshield washer
system
When the washer system is
switched on, the wipers also
operate.
7 Windshield wiper speeds
0 Windshield wiper switched off
1 Intermittent wiping
II Normal wiper speed
III High wiper speed
Hint:
If one of the turn signals fails, the turn
signal indicator system flashes and
sounds at a faster sequence than
under normal operating conditions.
Advertisement
Table of Contents
