Safety - Mercedes-Benz Citan 2015 Operating Instructions Manual

Table of Contents

Advertisement

Useful information
These Operating Instructions describe all
i
models as well as standard and optional
equipment of your vehicle that was available
at the time of going to print. Country-specific
variations are possible. Note that your vehicle
may not be fitted with all of the described
functions. This also applies to safety-relevant
systems and functions.
i
Read the information on qualified specialist
Y
workshops (
page 18).
Occupant safety
Restraint system introduction
The restraint system can reduce the risk of vehi-
cle occupants coming into contact with parts of
the vehicle's interior in the event of an accident.
The restraint system can also reduce the forces
to which vehicle occupants are subjected during
an accident.
The restraint system comprises:
Seat belt system
R
Airbags
R
Child restraint system
R
Child seat securing systems
R
The components of the restraint system work in
conjunction with each other. They can only
deploy their protective function if all vehicle
occupants always:
fasten their seat belts correctly
R
Y
(
page 31)
adjust their seat and head restraint properly
R
Y
(
page 67).
As the driver, you also have to make sure that
the steering wheel is adjusted correctly.
Observe the information relating to the correct
driver's seat position (
You also have to make sure that an airbag can
inflate properly if deployed (
An airbag supplements a correctly fastened seat
belt. As an additional safety device, the airbag
increases the level of protection for vehicle
occupants in the event of an accident. For exam-
ple, if the protection of the seat belt is sufficient
in an accident, the airbags are not deployed. In
the event of an accident, only the airbags that
increase protection in the relevant accident sit-
Y
page 66).
Y
page 33).
Occupant safety
uation are deployed. However, seat belts and
airbags generally do not protect against objects
penetrating the vehicle from the outside.
Information on the restraint system operation
can be found under "Triggering of belt tension-
Y
ers and airbags" (
page 35).
For more information about children travelling
with you in the vehicle, see "Children in the vehi-
Y
cle" (
page 36).
Important safety notes
G
WARNING
If the restraint system is modified, it may no
longer work as intended. The restraint system
may then not perform its intended protective
function by failing in an accident or triggering
unexpectedly, for example. There is an
increased risk of injury, possibly even fatal.
Never modify parts of the restraint system. Do
not attempt to modify the wiring as well as
electronic components or their software.
If it is necessary to modify an airbag system to
accommodate a person with disabilities, con-
tact a Mercedes-Benz Service Centre.
Restraint system warning lamp
The functions of the restraint system are
checked after the ignition is switched on and at
regular intervals while the engine is running.
Therefore, malfunctions can be detected in
good time.
The 6 restraint system warning lamp in the
instrument cluster lights up when the ignition is
switched on. It goes out no later than a few sec-
onds after the vehicle is started. The compo-
nents of the restraint system are in operational
readiness.
A malfunction has occurred if the 6 restraint
system warning lamp:
does not light up after the ignition is switched
R
on
does not go out after a few seconds with the
R
engine running
lights up again while the engine is running
R
29
Z

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents