Table of Contents
Advertisement
Back of GBE Board
7.
Install RF board into unit controller. Line up pins in RF board and press firmly into black connectors. Note ori-
entation of RF board (see Figure 25). Make sure the RF board is fully seated into all of the socket. Reconnect
power.
8.
Follow the directions on the next page to program BOTH the main and remote monitor units to communicate
with each other. If modem has been installed in the remote, it is also necessary to follow the directions in the
next section of this manual to configure the main controller to use the modem in the remote.
Wireless Remote Setup
Begin the wireless setup using the wireless remote device.
RUNNING
JAN-01-12
12:01P
1) INFORMATION
>2) SETUP
3) DIAGNOSTICS
>1) RF SETUP
2) MODEM SETUP
Wireless Remote Settings
Screen Display
CHANNEL #
1
RF FREQUENCY
915 Mhz
RUNNING
JAN-01-12
12:01P
Culligan® Series G1 Reverse Osmosis
42
Figure 25.
RF board location on GROC board.
1.
From the default home screen, press
2.
Press
to select 2)SETUP.
3.
Press
to select 1)RF SETUP.
Range
1–254
Press
or
valve. The CHANNEL # for the RO controller must be the same as the CHAN-
NEL # for the Remote Display.
433, 869,
Use this setting to select the correct radio frequency. Do not change the RF fre-
or 915
quency for North America installations.
4.
Press
to save the settings and return to the home screen.
RF Board (note orientation)
. The screen displays the main menu.
Changing the Setting
and then
to select the channel number of the control
Cat. No. 01021713
42
Hide quick links:
Advertisement
Table of Contents
