Program Data Input; Gbe Ro Controller Program Data - Culligan G1 Series Installation, Operation And Service Instructions

Program Data Input

There are a few items to note that can make programming the Culligan
Slew Rates This term refers to the speed at which the display moves through the input of material. For ex-
ample, holding down the up arrow key for (5) seconds when inputting minutes for Time of Day
will cause the minutes to pass in (10) minute blocks of time. Press the up arrow or down arrow
keys for shorter periods (less than 5 seconds) will slow the rate. To move through the program-
ming slowly, do not hold down the up arrow or the down arrow keys.
Beeper A beeper is available to assist the user by providing an audible tone (about 70 decibels) to signi-
fy valid (one beep) and invalid (three beeps) key presses. The beeper can be deactivated in the
programming mode. (If error occurs, beep will still sound even if set to "No" programming.)
Programming If there is no keypad activity for a one (1) minute period while in the programming mode, the
Mode Timeout controller will exit the programming mode and return to the main display. Any setting that was
changed prior to the control timing out will revert to the original value. Pressing the CHECK
MARK button saves the setting.
Program Input For programming information to be accepted, the check mark key must be depressed prior to
Acceptance programming mode timeout.
Cat. No. 01021713

GBE RO Controller Program Data

Global RO Controller easier:
®
GBE RO Controller Program Data 19