Installing the Modem In the Remote
Open the remote monitor housing by removing the two screws and squeezing the sides of the monitor housing slightly.
Insert the modem board (P/N 01020307) into the socket on the back of the remote board (see Figure 27). Make sure that
all of the pins in all four connectors are aligned and make sure the modem is fully seated into all of the sockets. Snap the
two halves of the remote housing back together using light finger pressure and insert the two screws.
GBE RO Controller Modem Setup
RUNNING
JAN-01-12
12:01P
1) GO TO RUNNING
2) GO TO OFFLINE
3) INFORMATION
>4) SETUP
2) LANGUAGE
3) POWERON MODE
4) FLUSH MODES
>5) ACCESSORIES
1) WIRELESS REM
>2) MODEM
3) FLOW METERS
4) SWITCH INPTS
Culligan® Series G1 Reverse Osmosis
46
Figure 27.
Modem installed on back of remote board.
1.
From the default home screen, press
2.
Press
to scroll to 4) SETUP.
3.
Press
to select the SETUP menu.
4.
Press
cessories menu.
5.
Press
to select 2)MODEM. The screen displays the modem settings.
. The screen displays the main menu.
to select 5)ACCESSORIES. The screen displays the ac-
Cat. No. 01021713
46