Pump/Motor Panel; Fittings; Prefilter Cartridge - Culligan G1 Series Installation, Operation And Service Instructions

Pump/Motor Panel

Hang the pump motor panel on the mounting bracket. The top edge of panel hooks on to the bracket. See Figure 5.

Fittings

Locate the Membrane Fitting Kit that was shipped with the unit. This kit includes all the fittings needed to connect the
membranes to the pump/motor panel. Refer to
you are installing and follow the tubing diagram. Detailed drawings of the fittings and housings can be found in the parts
section.

Prefilter Cartridge

1. Locate the prefilter cartridge packed with the main unit.
2. Unscrew the prefilter bowl.
3. Lubricate the seal ring with silicone lubricant as required.
4. Remove the paper wrapper from the cartridge, place the cartridge in the bowl, and screw the bowl onto the
head.
Culligan® Series G1 Reverse Osmosis
8
Mounting Bracket
Figure 5. Pump motor panel hanging on mounting bracket.
Figure 11 on page 13
Inlet
Figure 6. Installing the Prefilter.
Motor Panel
through Figure 15 on page 17
Pressure
Relief
Button
Outlet
Filter Cartridge
for the model
Cat. No. 01021713
8