Table of Contents
Advertisement
Motor tests
For non-touch-screen printer models, press
1
Enter the Diagnostics menu, and then navigate to:
Additional input tray diagnostics > Motor tests
2
Select a motor, and then press
Notes:
•
If the motor is activated, then it is properly working.
•
Some motors require automatic deactivation in order to avoid secondary issues such as possible
damage and contamination.
•
Some tests require a special action to activate a motor such as removing a major component.
•
If the motor fails, the test failure may not indicate a failed motor. Further troubleshooting may be
required. Check the boards and cables for possible issues.
Configuration Menu
Menu item
USB Configuration
USB PnP
1*
2
USB Configuration
USB Scan to Local
On*
Off
USB Configuration
USB Speed
Full
Auto*
Tray Configuration
Tray Linking
Automatic*
Off
Tray Configuration
Show Tray Insert Message
Off
Only for unknown sizes*
Always
Note: An asterisk (*) next to a value indicates the factory default setting.
to navigate through the settings.
or touch Start.
Description
Change the USB driver mode of the printer to improve its
compatibility with a personal computer.
Set whether the USB device driver enumerates as a USB
Simple device (single interface) or as a USB Composite device
(multiple interfaces).
Set the USB port to run at full speed and disable its high‑speed
capabilities.
Set the printer to link the trays that have the same paper type
and paper size settings.
Show the Tray Insert message.
Service menus
180
7017-2xx, -4xx, -6xx
Advertisement
Table of Contents
