Lexmark MB2338 Service Manual page 130

Fuser high temperature error service check
Action
Step 1
a
Remove the right cover. See
page 223.
b
Reseat the cooling fan cable on the controller board.
c
Check the cooling fan for damage.
Is the fan free of damage?
Step 2
Replace the fan. See
Does the problem remain?
Step 3
a
Remove the rear door and cover. See
removal" on page
b
Reseat all the cables from the controller board.
c
Reseat all the cables from the power supply.
Does the problem remain?
Step 4
a
Turn off the printer, and then remove the power cord.
b
Check if the resistance (between terminals A and D) of the
power supply socket is close to 30 ohms.
Does the socket have a normal resistance value?
Step 5
a
Disconnect the fuser cable from the power supply, plug the
power cord, and then turn on the printer.
b
Check if the voltage output of the fuser cable socket on the
power supply is normal (100V, 110V, or 220V).
CAUTION—SHOCK HAZARD: To avoid the risk of
electrical shock, do not touch the exposed wires and circuits.
Does the power supply provide the fuser with the normal voltage
value?
"Right cover removal" on
"Cooling fan removal" on page
"Rear door and cover
273.
Diagnostics and troubleshooting
Yes
Go to step 3.
Go to step 3.
227.
Go to step 4.
Go to step 5.
Go to step 6.
130
7017-2xx, -4xx, -6xx
No
Go to step 2.
The problem is
solved.
The problem is
solved.
Go to step 7.
Go to step 7.