Enable Or Disable The Display Backlight; Enable Or Disable Status Led Blinking - Emerson Micro Motion 2700 Configuration And Use Manual

2.
5.1.6

Enable or disable the display backlight

Display
ProLink III
Field Communicator Configure > Manual Setup > Display > Backlight
Overview
You can enable or disable the display backlight.
Procedure
Enable or disable Backlight.
The default setting is Enabled.
5.1.7

Enable or disable Status LED Blinking

Display
ProLink III
Field Communicator Configure > Manual Setup > Display > Display Variable Menu Features > Status LED Blink-
Overview
By default, the status LED blinks (flashes) to indicate unacknowledged alarms. If you
disable Status LED Blinking, the status LED does not blink, whether alarms are
acknowledged or not. It still changes color to indicate active alarms.
Procedure
Enable or disable Status LED Blinking.
The default setting is Enabled.
Configuration and Use Manual
Option Description
Disabled (de- The display shows Display Variable 1 and does not scroll automatically. The
operator can move to the next display variable at any time using Scroll.
fault)
If you enabled Auto Scroll, set Scroll Rate as desired.
The default value is 10 seconds.
Tip
Scroll Rate may not be available until you apply Auto Scroll.
OFF-LINE MAINT > OFF-LINE CONFG > DISPLAY > BKLT
Device Tools > Configuration > Transmitter Display > General
Not available
Device Tools > Configuration > Transmitter Display > General
ing
Configure device options and preferences
71