Setting Scanning For Transmission - Oki MC363 Advanced Manual

Setting Scanning for Transmission

This section describes the scan settings for Internet Fax transmissions.
If using Scan to Fax Server, the following scan settings are not available.
• Setting a reply destination
• Editing an e-mail
• Specifying a file name (file name)
• Scanning a duplex document (duplex scan)
Scanning Multiple Documents Continuously (Continuous Scan)
You can scan a fax transmission document from the ADF and document glass. For example,
you can send a document and a part of a book as a single fax job.
1
Press the (FAX) button on the operator panel.
2
Set a document in the ADF or on the document glass.
3
Press the button to select [Internet Fax] and press the
4
Press the or button to select [Continuous Scan] and press the
button.
5
Press the or button to select [ON] and press the
6
Specify a destination.
Entering a Destination E-mail Address
Specifying a Destination from Address Book/Group List
Selecting a Destination Using One Touch Buttons
Selecting a Destination from Transmission History
Searching for a Destination in the LDAP Server
7
Press the (MONO) button to start scanning the first document.
8
When [Please set next document] is displayed, set the next document.
9
Check that [Start Scan] is selected, and then press the
10
Repeat steps 8 and 9 for each fax transmission document if necessary.
11
When scanning all sets of the documents is complete, select [Scan Complete]
and press the
Adjusting the Density (Density)
You can adjust the density in seven levels.
1
Press the
2
Set a document in the ADF or on the document glass.
3
Press the
4
Press the
5
Press the
6
Press the
button.
button.
[0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density,
select [-1], [-2], or [-3] (lightest).
7
Specify a destination.
Entering a Destination E-mail Address
(OK) button.
Specifying a Destination from Address Book/Group List
Selecting a Destination Using One Touch Buttons
Selecting a Destination from Transmission History
Searching for a Destination in the LDAP Server
8
Change other settings if necessary, and then press the
You can change other settings for fax transmissions.
Setting Scanning for Transmission
Sending a Fax via the Internet
(OK) button.
- 141 -
(OK) button.
(FAX) button on the operator panel.
button to select [Internet Fax] and press the
or button to select [Scan Setting] and press the
button to select [Density] and press the
or button to select the density, and then press the
5. Fax
button.
button.
button.
(OK)
(MONO) button.