Table of Contents
Advertisement
Safety
Product
Introduction
Information
information
Trip
SLX.Er
Solutions Module slot X trip: Solutions Module in slot X has detected a fault
Fieldbus module category
Check value in Pr 15/16/17.50. The following table lists the possible error codes for the Fieldbus modules.
Error code
52
61
65
66
67
68
202,207,212
69
70
71
74
98
99
SLX.HF
Solutions Module slot X trip: Solutions Module X hardware fault
Ensure Solutions Module is fitted correctly
200,205,210
Return Solutions Module to supplier
SLX.nF
Solutions Module slot X trip: Solutions Module has been removed
Ensure Solutions Module is fitted correctly
203,208,213
Re-fit Solutions Module
Save parameters and reset drive
SL.rtd
Solutions Module trip: Drive mode has changed and Solutions Module parameter routing is now incorrect
Press reset.
215
If the trip persists, contact the supplier of the drive.
SLX.tO
Solutions Module slot X trip: Solutions Module watchdog timeout
Press reset.
201,206,211
If the trip persists, contact the supplier of the drive.
t010
User trip defined in 2
10
SM-Applications program must be interrogated to find the cause of this trip
t036 to t038
User trip defined in 2
36 to 38
SM-Applications program must be interrogated to find the cause of this trip
t040 to t089
User trip defined in 2
40 to 89
SM-Applications program must be interrogated to find the cause of this trip
t099
User trip defined in 2
99
SM-Applications program must be interrogated to find the cause of this trip
t111 to t160
User trip defined in 2
111 to 160
SM-Applications program must be interrogated to find the cause of this trip
t168 to t175
User trip defined in 2
168 to 175
SM-Applications program must be interrogated to find the cause of this trip
t177 to t178
User trip defined in 2
177 to 178
SM-Applications program must be interrogated to find the cause of this trip
t216 to t217
User trip defined in 2
216 to 217
SM-Applications program must be interrogated to find the cause of this trip
212
System
Mechanical
Electrical
design
installation
installation
Fieldbus Option
All except DPLCAN
Control word user trip
All
Invalid configuration parameters.
All except DPLCAN
Network loss
DeviceNet, CANopen and
"Bus-Off" Node sees an excessive number of transmission errors.
DPLCAN
CANopen
Node has not received a SYNC telegram within a specified time - to be defined.
CANopen
Node has not received the guarding telegram within the time period specified.
Node sends a data frame and no other node acknowledges
DPLCAN
receipt of the frame message.
No valid Fieldbus Menu data available in the module to download to the drive –
All
The user may not have saved any data, or the data save may not have been
completed successfully.
The External power supply has been lost. This trip will only occur if the module
DeviceNet
was on line with a master when the loss occurs. i.e. will not occur if the power
supply is not present during module initialisation.
All
The Solutions Module has overheated.
All
The Solutions Module background task has not been completed.
All
Software Fault.
nd
processor Solutions Module code
nd
processor Solutions Module code
nd
processor Solutions Module code
nd
processor Solutions Module code
nd
processor Solutions Module code
nd
processor Solutions Module code
nd
processor Solutions Module code
nd
processor Solutions Module code
www.controltechniques.com
Getting
Optimisation
Parameters
started
Diagnosis
Reason for fault
Technical
Component
Diagnostics
data
sizing
Unidrive SP Regen Installation Guide
Issue Number: 2
- Quick Links:
- Trip Indications
- Alarm Indications
Hide quick links:
Advertisement
Table of Contents
