Powered-Up Time: Hours.minutes; Run Time: Years.days; Run Time: Hours.minutes; Energy Meter: Mwh - Emerson SP1201 Installation Manual

Safety Product
Introduction
Information information
6.21

Powered-up time: hours.minutes

Drive mode Regen
Bit SP
Coding
Range Regen
Update rate Background
The powered-up clock always starts at zero each time the drive is powered-up. The time can be changed by the user from the keypad, serial comms
or an application module. If the data is not written with the various parts in the correct range (i.e. minutes are greater than 59, etc.) the clock is set to
zero on the next minute. This clock may be used for time stamping the trip log if Pr 6.28 = 0.
6.22

Run time: years.days

Drive mode Regen
Bit SP
Coding
Range Regen
Update rate Background
6.23

Run time: hours.minutes

Drive mode Regen
Bit SP
Coding
Range Regen
Update rate Background
The run time clock increments when the drive inverter is active to indicate the number of minutes that the drive has been running since leaving the
Control Techniques factory. This clock may be used for time stamping the trip log if Pr 6.28 = 1.
6.24

Energy meter: MWh

Drive mode Regen
Bit SP
Coding
Range Regen
Update rate Background
6.25 Energy meter: kWh
Drive mode Regen
Bit SP
Coding
Range Regen
Update rate Background
Pr 6.24 and Pr 6.25 form the energy meter that indicates energy supplied to/from the drive in kWh. For motor control modes a positive value indicates
net transfer of energy from the drive to the motor. For regen mode a positive value indicates a net transfer of energy from the supply to the drive. The
energy meter is reset and held at zero when Pr 6.17 is one.
6.26 Running cost
Drive mode Regen
Bit SP
Coding
Range Regen
Update rate Background
Instantaneous read out of the cost/hour of running the drive. This requires Pr 6.16 to be set up correctly.
114
System Mechanical
design installation
FI DE Txt VM DP ND
2 1
0 to 23.59 Hours.Minutes
FI DE Txt VM DP ND
3 1
0 to 9.364 Years.Days
FI DE Txt VM DP ND
2 1
0 to 23.59 Hours.Minutes
FI DE Txt VM DP ND
1 1
±999.9 MWh
FI DE Txt VM DP ND
2 1
±99.99 kWh
FI DE Txt VM DP ND
1 1
±32,000
www.controltechniques.com
Electrical Getting
Optimisation
installation started
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
Technical Component
Parameters
data
PS
1 1
PS
1 1
PS
1 1
PS
1
PS
1
PS
Unidrive SP Regen Installation Guide
Diagnostics
sizing
Issue Number: 2