Drive Onboard Plc Programming Events; Drive Onboard Plc Program Maximum Scan Time; Drive Onboard Plc Program First Run - Emerson SP1201 Installation Manual

Safety Product
Introduction
Information information
11.49

Drive Onboard PLC programming events

Drive mode Regen
Bit SP
Coding
Range Regen
Update rate Background
The drive Onboard PLC programming events parameter holds the number of times a Onboard PLC program download has taken place and is 0 on
dispatch from the factory. If the drive Onboard PLC programming events is greater than the maximum value which may be represented by this
parameter the value will be clipped to the maximum value. This parameter is not altered when defaults are loaded.
11.50

Drive Onboard PLC program maximum scan time

Drive mode Regen
Bit SP
Coding
Range Regen
Update rate Onboard PLC program execution period
The Onboard PLC program maximum scan time parameter gives the longest scan time within the last ten scans of the drive Onboard PLC program.
If the scan time is greater than the maximum value which may be represented by this parameter the value will be clipped to the maximum value.
11.51

Drive Onboard PLC program first run

Drive mode Regen
Bit SP
Coding
1
Range Regen
Update rate Onboard PLC program execution period
The drive Onboard PLC program first run parameter is set for the duration of the first ladder diagram scan from the ladder diagram stopped state. This
enables the user to perform any required initialisation every time the ladder diagram is run. This parameter is set every time the ladder is stopped.
164
System Mechanical
design installation
FI DE Txt VM DP ND
1
0 to 65,535
FI DE Txt VM DP ND
1
0 to 65,535 ms
FI DE Txt VM DP ND
1
0 or 1
www.controltechniques.com
Electrical Getting
Optimisation
installation started
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
RA NC NV PT US RW BU
1 1
Technical Component
Parameters
data sizing
PS
1 1
PS
1
PS
Unidrive SP Regen Installation Guide
Diagnostics
Issue Number: 2