Changing The User Parameters - Ricoh 2015 General Settings Manual

Changing the User Parameters

Important
❒ We recommend you print and
keep a User Parameter list when
you program or change a User Pa-
rameter. See p.84 "Printing the
User Parameter List".
❒ Do not change any bit switches
other than those shown on the pre-
vious pages.
A A A A
Press the { { { { User Tools/Counter} } } } key.
User Tools/
Counter
On Hook Dial On Hook Dial
B B B B
Select [Fax Features] using { { { { U U U U } } } } or
{ { { { T T T T } } } } , and then press the { { { { OK} } } } key.
C C C C
Select [Key Operator Tools] using
{ { { { U U U U } } } } or { { { { T T T T } } } } , and then press the
{ { { { OK} } } } key.
D D D D
Select [Parameter Setting] using { { { { U U U U } } } }
or { { { { T T T T } } } } , and then press the { { { { OK} } } }
key.
E E E E
F F F F
Clear
Modes
Clear/Stop
AAN215F
G G G G
H H H H
I I I I
J J J J
Using Key Operator Settings
Select [Parameter Setting] using { { { { U U U U } } } }
or { { { { T T T T } } } } , and then press the { { { { OK} } } }
key.
Select the switch number you
want to change using { { { { U U U U } } } } or { { { { T T T T } } } } ,
and then press the { { { { OK} } } } key.
Select the bit number you want to
change.
When the bit number is pressed,
the current value switches be-
tween 1 and 0.
Note
❒ Repeat from step
another bit number for the same
switch.
Press the { { { { OK} } } } key.
Note
❒ To cancel these settings, press
the { { { { Cancel} } } } key. The display re-
turns to that of step
F F F F
Repeat steps and
the switch settings.
After all the settings are finished,
press the { { { { User Tools/Counter} } } } key.
The standby display appears.
7
G
to change
F
.
G G G G
to change
83