Ricoh 2015 General Settings Manual page 659

Configuring a Windows NT 4.0
Computer
Follow the procedure below to con-
figure a Windows NT 4.0 computer to
use TCP/IP.
A A A A
Open [Control Panel], and then
double-click the Network icon.
Make sure [TCP/IP Protocol] is se-
lected in the [Network protocols]
box on the [Protocols] tab.
Note
❒ Select TCP/IP if it is not already
selected.
❒ If TCP/IP is not installed, click
[Add] on the [Protocols] tab to in-
stall it. For more information
about installing TCP/IP, see
Windows NT 4.0 Help.
B B B B
Click [Properties].
C C C C
Configure TCP/IP using the ap-
propriate IP address, subnet
mask, and other settings.
Check with the network adminis-
trator that the settings are correct.
Configuring TCP/IP
37
4