Ricoh 2015 General Settings Manual page 376

Troubleshooting
Problem
When using Win-
dows 95/98/Me,
Windows
2000/XP, or Win-
dows NT 4.0, ei-
ther combined
printing or book-
2
let print does not
come out as ex-
pected.
When using Win-
dows 95/98/Me,
Windows
2000/XP, or Win-
dows NT 4.0,
Auto Reduce/En-
large print does
not come out as
expected.
A print instruc-
tion was issued
from the compu-
ter, but printing
did not start.
The print job is not
canceled even
when the machine
is switched to of-
fline status.
Photo images are
coarse.
Images are cut off,
or excess is print-
ed.
20
Make sure the application's paper size and orientation settings match those
of the printer driver.
If a different paper size and orientation are set, select the same size and ori-
entation.
User code management may have been set. Ask the administrator about
valid user codes. To print, the user code must be entered from the printer
driver.
Even when the machine is offline, printing is performed when [Job accept-
ance priority] is selected for [Signal Control] in [Parallel Interface] in [Interface
Settings] in [System Settings]. Select [Printer priority] for [Signal Control].
See "User Tools (System Settings)", General Settings Guide.
Some applications reduce print resolution.
You may be using paper smaller than the size selected in the application.
Use the same size paper as that selected in the application. If you cannot
load paper of the correct size, use the reduction function to reduce the im-
age, and then print.
See the printer driver Help.
Causes and Solutions