Ricoh 2015 General Settings Manual page 710

Appendix
Example output:
port 9100
timeout=300(sec)
bidirect off
• "Port" specifies the port number
of the direct printing port.
• The "bidirect" setting indicates
whether the direct printing port
is bidirectional or not.
❖ ❖ ❖ ❖ Setting timeout
You can specify the timeout inter-
val in use when receiving data
from the network.
msh> diprint timeout
[30~65535]
Note
❒ The default is 300 seconds.
❖ ❖ ❖ ❖ Bidirectional configuration for the di-
rect printing port
Use this setting to configure
whether the direct printing port is
bidirectional or not. The default is
"off".
msh> diprint bidirect {on
| off}
Note
9
❒ If you select "on", SmartDevice-
Monitor for Client or Standard
T C P / I P o n W i n d o w s 2 0 0 0
might not work correctly.
88
Netware
Use the "netware" command to con-
figure the NetWare settings such as
the print server name or file server
name.
msh> netware parameter
Parameter Settings
pname Enter the NetWare print serv-
er name using up to 47 char-
acters.
fname Enter the NetWare file server
name using up to 47 charac-
ters.
encap Select the encap type.
[802.3/802.
2/snap/
ethernet2/
auto]
rnum Specify the remote printer
number.
timeout Set the timeout.
mode Select the print server mode.
{pserver |
ps}
mode Select the remote printer
{rprinter | mode.
rp}
context Specify the NDS context
name.
sap_interva Specify the SAP intervals.
l
Each interval can be set to be-
tween 0 and 3600 seconds in
one-second increments.
login server Specify "login with a selected
file server" as the login mode.
login tree Specify "login with a selected
NDS tree" as the login mode.
tree NDS Select the NDS tree to log on
tree name to.