Installing The Long Path Cell Holder; Installing A Sample Cell - Agilent Technologies Cary 8454 Installation Manual

Installing the Long Path Cell Holder

1 Loosen the hold- down screws and remove the current sample holder
2 Orient the long path cell holder so that the clamps that hold the sample
3 Tighten the hold- down screws.

Installing a Sample Cell

1 Position the cell stops according to the path length of the sample cell
Cell stops
Position cell here
Figure 18
Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide
from the sample compartment.
cell in place are on the right. Lower the cell holder onto the sample
compartment mounting guides.
you will be using. This example shows a 1- cm sample cell:
Positioning the cell stops for a 1-cm sample cell
Installing Accessories
Long Path Cell Holder
Cell clamps
Clamp screws
4
59