Installing Non-Preconfigured Agilent Cary 8454 Uv-Visible Spectrophotometer Systems - Agilent Technologies Cary 8454 Installation Manual

Installing Non-Preconfigured Agilent Cary 8454 UV-Visible Spectrophotometer Systems

Installing Non-Preconfigured Agilent Cary 8454 UV-Visible
Spectrophotometer Systems
You must install and configure the software. In addition, you may need to
install and configure an instrument communication interface such as the
GPIB PCI interface card.
Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide
Ensure you have space and an appropriate power supply.
For more information, see
Spectrophotometer"
Unpack the system - check for damage and contents against packing
list.
For more information, see
page 22.
Install your UV- Visible spectrophotometer.
• Connect the line power to the rear.
• Connect the waste tubing underneath the sample pan.
For more information, see
Spectrophotometer"
If your computer and printer are not supplied by Agilent, ensure that
the requirements for proper operation of the software are met.
For more information, see
Agilent ChemStation"
Install the GPIB interface board in your computer.
For more information, see
Install your computer and printer.
• Connect the keyboard and mouse.
• Connect the monitor to the power supply and to the computer.
• Connect the printer to the power supply and to the computer.
• Connect the computer to the spectrophotometer with the GPIB cable.
"Site Requirements for Your
on page 19.
"Unpacking Your Spectrophotometer"
"Installing your UV- Visible
on page 23.
"Minimum PC Requirements for
on page 66.
"Installing an GPIB Interface"
Fast Installation 1
on
on page 81.
13