Agilent Technologies Cary 8454 Installation Manual page 115

2 In the 'Local Area Connection Properties' dialog
If the device is not working properly or no network interface card is configured, please refer
N O T E
to the hardware manual of your network card and the PC for how to install and configure a
network interface card.
3 In the 'This connection uses the following items:' section of this dialog
If the TCP/IP protocol is not installed, use the Install button, select Protocol from the list of
N O T E
network components to install and press Add.
From the 'Manufacturers:' select 'Microsoft' and from the 'Network Protocol:' select the
'Internet Protocol Version 4(TCP/IPv4)' and press 'OK'. If required, reboot your computer.
4 Select the 'Internet Protocol Version 4(TCP/IPv4)' and click Properties.
If the PC is connected to your companies LAN, do not change any setting. Note down the
N O T E
'Subnet Mask' if available. Ask your responsible IT consultant for this mask if not available
and request a fixed IP address for your instrument, if you want to use the existing LAN for
the instrument connection.
For further details please
Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide
LAN Communication, Installation, Connection and Configuration
Configure... to make sure the device is working properly.
make sure the 'Internet Protocol Version 4(TCP/IPv4)' is available
and checked.
see"Connecting the Spectrophotometer to the
Installing and Configuring TCP/IP on the PC
(see Figure 56) click
PC".
7
115