Agilent Technologies Cary 8454 Installation Manual page 60

4 Installing Accessories
Long Path Cell Holder
2 If your sample cell is not one of the standard lengths, position the cell
3 Because the light beam is collimated, absolute positioning of the sample
4 Install the sample cell between the clamps. Slide it against the cell stop.
5 Allow the clamps to close against the sample cell, see
Figure 19
60
stops as for a long path sample cell, i.e. move all cell stops in
to the left.
cell is not important; however, consistent cell positioning gives more
consistent results. The cell stops make it easier to consistently position
your sample cells.
If your sample cell is not one of the standard lengths, position it so the
clamps are gripping the mid- point of the cell.
Tighten the four screws that hold the sample cell in place.
Installed 10-cm cylindrical cell in the long path cell holder
Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide
Figure 18
Figure 19.