Installing Preconfigured Agilent Cary 8454 Uv-Visible Systems - Agilent Technologies Cary 8454 Installation Manual

1 Fast Installation

Installing Preconfigured Agilent Cary 8454 UV-Visible Systems

Installing Preconfigured Agilent Cary 8454 UV-Visible Systems
If you have purchased one of these systems, the software is pre- installed
and preconfigured. You need only install and switch on the hardware.
12
Ensure you have space and an appropriate power supply.
For more information, see
Spectrophotometer"
Unpack the system—check for damage and contents against packing list.
For more information, see
page 22.
Install your UV- Visible spectrophotometer.
• Connect line power to the rear.
• Connect the waste tubing underneath the sample pan.
For more information, see
Spectrophotometer"
Install your computer and printer.
• Connect the keyboard and mouse.
• Connect the monitor to line power and to the computer.
• Connect the printer to line power and to the computer.
• Connect the computer to the spectrophotometer with the GPIB or
LAN cable.
For more information, see
Chapter 7, "LAN Communication, Installation, Connection and
Configuration".
Switch on the spectrophotometer (make sure the sample area is clear),
wait 2 minutes for the lamps to ignite. When you are ready to operate
your spectrophotometer, switch on the computer and printer.
For more information, see
Agilent Cary 8454 UV-Visible Spectroscopy System Installation Guide
"Site Requirements for Your
on page 19.
"Unpacking Your Spectrophotometer"
"Installing your UV- Visible
on page 23.
"Installing Your Computer"
"Starting the Spectrophotometer"
on
on page 29 and
on page 31.