Bfd Mad-Enabled Irf Configuration Example For A Two-Chassis Irf Fabric - HP FlexFabric 12900 Series Configuration Manual

BFD MAD-enabled IRF configuration example for a two-chassis
IRF fabric
Network requirements
As shown in
• Configure BFD MAD in the IRF fabric and set up BFD MAD links between the member devices.
Disable the spanning tree feature on the ports used for BFD MAD, because the two features conflict
•
with each other.
Figure 13 Network diagram
Configuration procedure
1. Configure IRF on Device A:
# Assign member ID 1 to Device A.
<Sysname> system-view
[Sysname] irf member 1
Info: Member ID change will take effect after the member reboots and operates in IRF
mode.
# Enable IRF mode.
[Sysname] chassis convert mode irf
The device will switch to IRF mode and reboot. You are recommended to save the current
running configuration and specify the configuration file for the next startup.
Continue? [Y/N]:y
Do you want to convert the content of the next startup configuration file
flash:/startup.cfg to make it available in IRF mode? [Y/N]:y
Please wait...
Figure 13, set up an IRF fabric at the distribution layer of the network.
Device A
(IRF-port1/2)
XGE1/3/0/1-1/3/0/4
BFD MAD
XGE1/4/0/1
IRF
Device B
(IRF-port2/1)
XGE2/3/0/1-2/3/0/4
XGE2/4/0/1
link
......
35