Configuring A Ripng Route Filtering Policy; Configuring A Priority For Ripng; Configuring Ripng Route Redistribution - HP 3600 v2 series Configuration Manual

Configuring a RIPng route filtering policy

Reference a configured IPv6 ACL or prefix list to filter received or advertised routing information. You can
also filter outbound routes redistributed from a routing specific routing protocol.
Follow these steps to configure a RIPng route filtering policy:
To do...
Enter system view
Enter RIPng view
Configure a filter policy to filter
incoming routes
Configure a filter policy to filter
outgoing routes

Configuring a priority for RIPng

Any routing protocol has its own protocol priority used for optimal route selection. You can set a priority
for RIPng manually. The smaller the value, the higher the priority.
Follow these steps to configure a RIPng priority:
To do...
Enter system view
Enter RIPng view
Configure a RIPng priority

Configuring RIPng route redistribution

Follow these steps to configure RIPng route redistribution:
To do...
Enter system view
Enter RIPng view
Configure a default routing metric
for redistributed routes
Redistribute routes from another
routing protocol
Use the command...
system-view
ripng [ process-id ]
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
import
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ protocol [ process-id ] ]
Use the command...
system-view
ripng [ process-id ]
preference [ route-policy
route-policy-name ] preference
Use the command...
system-view
ripng [ process-id ]
default cost cost
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
268
Remarks
––
––
Required
By default, RIPng does not filter
incoming routing information.
Required
By default, RIPng does not filter
outgoing routing information.
Remarks
—
—
Optional
By default, the RIPng priority is
100.
Remarks
––
––
Optional
The default metric of redistributed
routes is 0.
Required
No route redistribution is
configured by default.