Position Of Coordinate System - Siemens SINUMERIK 840D sl Commissioning Manual

MD9424 = 0
MD9424 = 1
References:
Function Manual, Basic Functions; Axes, Coordinate Systems, Frames (K2)
3.20.2

Position of coordinate system

Milling
The position of the coordinate system for milling is set in display machine data
MD9650 $MM_CMM_POS_COORDINATE_SYSTEM.
Table 3-1
Default setting 0
Data type BYTE
Meaning
Technology
The position of the coordinate system for the technology is set in display machine data
MD9610 $MM_CTM_POS_COORDINATE_SYSTEM.
References
Function Manual, Basic Functions, Mode Group, Channel, Program Operation, Reset
Behavior (K1)
Commissioning HMI-Embedded (IM2)
Commissioning Manual, 01/2008, 6FC5397-8CP10-1BA0
Display in workpiece coordinate system, WCS (default)
Display in the settable zero system, SZS (fixture position of the
active tool)
Machine data 9650
9650 MD number CMM_POS_COORDINATE_SYSTEM
Position of coordinate system
Min. input limit: 0
With this machine data you adapt the coordinate system of the
user interface to the coordinate system of the machine.
The coordinate system can assume the following positions.
Functions
3.20 Coordinate systems
Units: -
Valid as of SW release:
SW 05.01.13
49