Dürkopp Adler 867 Service Instructions Manual page 23

Working basis
There are two securing positions:
• Position 1: Loop stroke position
• Position 2: Handwheel zero position
Fig. 10: Locking the sewing machine in place
Locking the machine in place
1. Remove the plug from the locking opening (2).
2. Turn the handwheel until the appropriate groove (1) is in front of the
3. Insert the locking peg (3) with the appropriate end into the groove (1).
Removing the locking mechanism
1. Pull the locking peg (3) out of the groove (1).
2. Insert the plug into the locking opening (2).
Service Instructions 867 - 03.0 - 10/2017
• 5 mm end in the large groove
• Setting the loop stroke and needle bar height
• 3 mm end in the small groove
• Setting the handwheel position and checking the top dead center
for the needle bar
①
②
(1) - Groove
(2) - Locking opening
locking opening (2):
• Small groove at handwheel position 0°
• Large groove at handwheel position 200 – 205°
③
(3) - Locking peg
21