Dürkopp Adler 867 Service Instructions Manual page 112

Setting steps
1. Undo the screws (3) of the toothed belt wheel (2).
2. Adjust the toothed belt wheel (2) such that the cutter only cuts when
3. Tighten the screws (2).
Adjusting the cutter stroke
Fig. 92: Adjusting the vertical cutter II
The stroke height of the cutter (1) can be set. This is necessary if the cutter
was reground and is now shorter.
Setting steps
1. Unscrew the cover (2).
2. Release the nut (3).
3. Turn the screw (4):
4. Tighten the nut (3).
5. Correct cutter overlap.
110
no material is being fed.
(1) - Cutter
(2) - Cover
• Turn screw upwards = stroke higher
• Turn screw downwards = stroke smaller
① ②
③
④
(3) - Nut
(4) - Screw
Service Instructions 867 - 03.0 - 10/2017
Special machines