Feed Dog Stroke (Default) - Dürkopp Adler 867 Service Instructions Manual

8.3 Feed dog stroke (default)

8.3.1 Setting the stroke movement
Order
First check the following setting:
• Feed-dog height ( p. 41)
Proper setting
At the front dead center (handwheel position 90°) and at the rear dead
center (handwheel position 270°) for the feed-dog, the upper edge of the
feed-dog is at the same height as the upper edge of the throat plates.
At 90°, the feed-dog is in the upward movement; at 270°, in the downward
movement.
Cover
• Tilt the upper section ( p. 14)
Fig. 27: Setting the feed-dog lift
Setting steps
1. Unscrew the setscrews (1).
2. Put the handwheel into the 90° position.
42
WARNING
Risk of injury
Crushing injuries from moving parts.
Switch the sewing machine off before you check
and set the stroke movement of the feed-dog.
①
(1) - Setscrews
Setting the feed-dog
(2) - Stroke eccentric
Service Instructions 867 - 03.0 - 10/2017
②