Machines With A Vertical Cutter - Dürkopp Adler 867 Service Instructions Manual

Special machines
3. Check for synchronous operation.
Fine adjustment of synchronous operation
4. Loosen the screw (6).
5. Remove the lever (4).
6. Adjust the clamp (5) on the shaft (2).

20.3 Machines with a vertical cutter

Sewing machines with a vertical cutter allow the sewing material to be cut
during the sewing process. The vertical cutter is disabled each time the
sewing feet are pneumatically lifted.
When the knee lever is actuated, it is only disabled after the second/third
lifting.
Setting the time for cutter movement
The cutter should cut the sewing material when material is not being fed.
Cover
Head cover ( p. 16)
Fig. 91: Adjusting the vertical cutter I
Service Instructions 867 - 03.0 - 10/2017
The clamp can be adjusted to the right or left as well as up or down.
WARNING
Risk of injury
Risk of crushing injuries and stab wounds from mov-
ing and sharp parts.
Switch off the sewing machine before setting the
vertical cutter.
(1) - Vertical cutter
① ②
(2) - Toothed belt wheel
(3) - Screws
③
109