Dürkopp Adler 867 Service Instructions Manual page 55

Position of the hook and needle
Cover
• Tilt the upper section ( p. 14)
• Feed-dog ( p. 19)
Fig. 36: Setting the loop stroke position
Setting steps
1. Lock the machine in place at position 1 ( p. 21).
2. Position the upper stitch length adjusting wheel to 0.
3. Loosen all four setscrews (2) for the hook clamping ring (1).
4. Turn the hook such that the hook tip (4) points exactly to the vertical
5. Tighten the setscrews (2) for the hook clamping ring (1).
6. Remove the lock (
Order
Then check the following settings:
• Position of the needle guard ( p. 54)
• Point in time in cutting for the thread cutter ( p. 78)
Service Instructions 867 - 03.0 - 10/2017
(1) - Clamping ring
(2) - Setscrews
center line of the needle (3).

(3) - Needle groove
(4) - Hook tip
p. 21).
53