Setting The Winder - Dürkopp Adler 867 Service Instructions Manual

14.2 Setting the winder

Proper setting
The winder wheel runs smoothly and without axial play.
The winding process will stop automatically when the required filling quan-
tity of the bobbin is reached.
Cover
• Arm cover ( p. 15)
Fig. 51: Removing the winder and setting the winder filling quantity
Removing the winder
1. Loosen the screws (1).
2. Remove the winder.
Setting the winder filling quantity
The position of the arms on the screw (2) determines the filling quantity:
3. Turn the screw (2):
70
WARNING
Risk of injury
Crushing injuries from moving parts.
Switch off the sewing machine before setting the
winder.
(1) - Screws
(2) - Screw
• Parallel: Automatic winding stop at 0.5 mm under the edge of the
winder
• Closer together: Automatic stop with larger filling quantity
• Further apart from each other: Automatic stop with smaller filling
quantity
• Arms closer together: Turn it counterclockwise
• Arms further apart from each other: Turn it clockwise
(3) - Winding lever
(4) - Arm
Service Instructions 867 - 03.0 - 10/2017
Winder