Dürkopp Adler 867 Service Instructions Manual page 113

Special machines
Correcting cutter overlap
Fig. 93: Adjusting the vertical cutter III
If the cutter (2) is at the lower dead center, the overlap should be 0.5 mm.
Setting steps
1. Loosen the screw (1).
2. Push the cutter (2) down until it overlaps with the counter-blade (3) by
3. Tighten the screw (1).
Adjusting the position and pressure of the cutting edges
Fig. 94: Adjusting the vertical cutter IIV
The cutter (2) should be somewhat diagonal to the counter-blade (3).
The cutter (2) should cut reliably with the least possible pressure.
Service Instructions 867 - 03.0 - 10/2017
①
(1) - Screw
(2) - Cutter
0.5 mm.
④
⑤
(4) - Cutter
(5) - Counter-blade
②
(3) - Counter-blade
②
(6) - Cutter holder
(7) - Screws
③
③
111