The hood has been trimmed slightly oversized to allow the panel gaps to be sanded down to fit. Set the hood in
place and make sure it will fit the opening in the body, if needed sand or file the edges to allow the panel to just
fit with a very small gap all around.
The bumpers are used to get the hood to the correct plane with the body, you can shave small amounts
off either or put washers as shims to fine tune as needed.
Put the small bumpers around the edge of the hood opening and try closing the hood. If it is too low try the
large bumpers.
328
www.factoryfive.com
508-291-3443