Factory Five Racing MK4 ROADSTER Assembly Manual page 327

the car by lining it up with the front "X" member so that the tape measure is parallel. Make this measurement
on each side of the body so that the front of the body is centered over the frame.
Move the front of the body as necessary. If the body will not stay where you put it, put a screw through the
hood lip of the body into the ¾" tube.
The hood opening is attached to the ¾" frame rails using countersunk sheet metal screws or the small bumpers
during the hood fitment next.
With the Body centered left to right and the quick jack sleeves centered in the holes, tighten the bolts.
Use a jack temporarily hold the bottom side of the body up to the frame.
326
www.factoryfive.com 508-291-3443