Factory Five Racing MK4 ROADSTER Assembly Manual page 223

Complete kit

Hide thumbs Also See for MK4 ROADSTER:

Table of Contents

Place the O-ring in the adapter groove.

If the O-ring will not seat properly, put it in the freezer for 15 minutes and use a small amount of chassis

grease to hold it in place while spinning on the adapter. Tighten ½ turn after solid resistance is felt. The

outlets for the hoses should be facing towards the front of the engine.

Install the oil filter relocate base plate on the engine.

Install the block off plugs (with a ⅜" hex key) in the adapter holes not being used. Use the Teflon tape on the

threads of the plugs as you tighten them. Wrap the Teflon tape so it stretches when you attach the plug into the

threaded socket. Max torque for the fittings on the relocate kit is 28 lbft.

www.factoryfive.com

508-291-3443