Programming Guide - Extron electronics XTP CrossPoint1600 User Manual

Programming Guide

The XTP CrossPoint Series Matrix Switcher can be remotely controlled via:
•
•
•
This section describes the operation of the XTP CrossPoint Series Matrix Switchers via SIS
commands, including:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
The XTP System Configuration software (see the XTP System Configuration Software
Help file, available at www.extron.com).
Built-in HTML pages (see HTML
SIS commands (see below)
Local Host-Control Ports
Ethernet (LAN) Port
Host-to-Matrix-Switcher Instructions
Matrix-Switcher-Initiated Messages
Matrix Switcher Error Responses
Using the Command and Response Tables
SIS Command and Response Table for Basic Matrix Switcher Commands
SIS Command and Response Table for Input-Board-Specific Commands
SIS Command and Response Table for Input-Endpoint-Specific Commands
SIS Command and Response Table for Output-Board-Specific Commands
SIS Command and Response Table for Output-Endpoint-Specific Commands
SIS Command and Response Table for Advanced Matrix Switcher Commands
SIS Command and Response Table for IP- and Remote Port-Specific
Commands
Special Characters
Operation, beginning on page 121)
XTP CrossPoint Series • Programming Guide 76