Creating A Configuration - Extron electronics XTP CrossPoint1600 User Manual

Creating a Configuration

The current configuration can be changed using the front panel buttons. Change the current
configuration as follows:
1. Press the
control button indicators that may be lit.
2. Press the
for configuration.
3. Press the input and output buttons to select the desired input and one or more outputs.
Input buttons and output buttons light or blink:
•
•
•
•
To indicate potential ties, output buttons blink the appropriate color when an input
•
is selected.
To indicate current ties, output buttons light steadily the appropriate color when an
•
input is selected.
To clear unwanted outputs, press and release the associated lit output buttons. To
•
indicate potential unties, output buttons blink the appropriate color when an output
is deselected but not untied from the input.
4. Press and release the
5. Repeat steps 1 through 4 to create or clear additional ties until the desired configuration
is complete.
NOTES:
•
•
•
•
•
button to clear any input button indicators, output button indicators, or
Esc
button and
Video Audio
Amber to indicate video and audio ties
Green to indicate video only ties
Red to indicate audio only ties
button to accept the tie or to break an existing tie.
Enter
Only one video input and one audio input can be tied to an output.
If a tie is made between an input and an output, and the selected output was
previously tied to another input, the older tie is broken in favor of the newer tie.
If an input with no tie is selected, only the button for the selected input lights.
When the button and the
Video
tie but no video tie is selected, the button for the input and the button for the
output light the appropriate color (amber, green, or red).
As each input and output is selected, the associated output button blinks
the appropriate color to indicate a tentative tie. Buttons for outputs that were
already tied to the input light the appropriate color steadily. Outputs that are
already tied can be left on, along with new blinking selections, or toggled off by
pressing the associated output button.
button as necessary to select video, audio, or both
button are lit, if an input with an audio
Audio
XTP CrossPoint Series • Operation 37