Green; White-Brown 7 White-Brown; Brown 8 Brown - Extron electronics XTP CrossPoint1600 User Manual

The cable used depends on your network speed. The matrix switcher LAN port supports
both 10 Mbps (10Base-T - Ethernet) and 100 Mbps (100Base-T - Fast Ethernet),
half-duplex and full-duplex Ethernet connections. Input and output boards support
100Base-T only.
• 10Base-T Ethernet requires CAT 3 UTP or STP cable at minimum.
100Base-T Fast Ethernet requires CAT 5e UTP or STP cable at minimum.
•
The TP cable can be terminated as a straight-through cable or a crossover cable and must
be properly terminated for your application.
Crossover cable - Direct connection between the computer and the XTP CrossPoint
•
matrix switcher.
Patch (straight) cable - Connection of the XTP CrossPoint matrix switcher to an
•
Ethernet LAN and connection to the input and output board XTP connectors.
Pins:
1 2 3 4 5 6 7 8
Side View
Insert Twisted
Pair Wires
RJ-45 Connector
Figure 17.
Matrix switcher and XTP board LAN ports -
The LAN ports require CAT 3, CAT 5e, or CAT 6a, crossover or patch cables.
Straight-through Cable
(for connection to a switch, hub, or router)
End 1 End 2
Pin Wire Color Pin Wire Color
1 white-orange 1 white-orange
2 orange 2 orange
3 white-green 3 white-green
4 blue 4 blue
5 white-blue 5 white-blue
6

green

6 green
7 white-brown 7 white-brown
8 brown 8 brown
RJ-45 Connector and Pinout Tables
Crossover Cable
(for direct connection to a PC)
End 1
Pin Wire Color Pin Wire Color
1 white-orange 1 white-green
2 orange 2 green
3 white-green 3 white-orange
4 blue 4 blue
5 white-blue 5 white-blue
6 green 6 orange
7 white-brown 7 white-brown
8 brown 8 brown
XTP CrossPoint Series • Installation
End 2
20