Input And Output Boards - Extron electronics XTP CrossPoint1600 User Manual

Input and Output Boards

On the XTP CrossPoint 1600, the top slots are for input boards and the bottom slots are for
output boards. On the XTP CrossPoint 3200, slots on the left are for input boards and slots
on the right are for output boards. Each board installed in a slot supports up to four inputs or
outputs of the applicable type (see
page 4, Input boards space
Input boards can be installed in any order in the input slot locations. Output boards can
likewise be installed in any order in the output slot locations. You can skip a slot with the only
result being that the inputs or outputs serviced by that slot location are not present in the
matrix. For example, if you omit installing a board in input slot 3, inputs 9 through 12 are not
present and the first connector in input slot 4 remains input 13.
NOTE: Audio ground pins on the input and output boards may be labeled as
The wiring and function are the same, whichever way the board is labeled.
Input boards space —
A
NOTE: See
Install input boards as desired in input slots 1 through 4 (XTP CrossPoint 1600) or slots
1 through 8 (XTP CrossPoint 3200) and make connections. See
or Output Board or Blank Panel
below.
NOTE: Install blank panels in unused locations to ensure proper ventilation.
XTP CP 4i and XTP CP 4i 4K (XTP input board)
INPUTS
PWR
2 2
Figure 4.
ATTENTION:
•
•
NOTE: PoX must be enabled using:
•
•
•
XTP input connectors — Connect an STP cable between a compatible Extron
1
XTP transmitter and this connector (see
connector).
XTP power indicators — Light to indicate that the input board is providing power
2
over XTP (PoX) to the transmitter connected to this RJ-45 connector.
Input and Output Boards and Signal Types
below, and
figure 2 on page 12 and
1 1 3 3 1 1 3 3 1 1
SIG LINK SIG LINK SIG
PWR PWR
XTP IN XTP IN XTP IN
LAN LAN
2 2 2 2
XTP Input Board Connectors and Indicators (XTP CP 4i 4K)
The XTP input board can provide power over XTP (PoX) to connected devices.
PoX is intended for indoors use only. No part of a network that uses PoX can
be routed outdoors.
La carte entrée XTP peut fournir l'alimentation sur XTP (PoX) aux appareils
connectés. PoX est destiné à une utilisation en intérieur uniquement. Aucune
partie d'un réseau qui utilise PoX ne peut être routée en extérieur.
SIS commands (see the applicable
Built-in HTML pages (see XTP Power Page
The XTP System Configuration software (see the XTP System Configuration
Software Help File, available at www.extron.com)
Output boards space on page 17).
figure 3 on page 13.
on page 147 and the individual board descriptions
3 3 1 1 3 3
LINK SIG LINK
PWR RS-232 IR
XTP IN
LAN LAN Tx Rx G Tx Rx
2 2
XTP Power SIS commands on page 93)
on page 143)
TP connectors on page 19 to wire the
XTP CrossPoint Series • Installation
on
or .
Installing the Input
OVER XTP XTP CP 4i 4K
RS-232 IR RS-232 IR RS-232 IR
Tx Rx G Tx Rx Tx Rx G Tx Rx Tx Rx G Tx Rx
4 4
14