Table of Contents
Advertisement
Host-to-Matrix-Switcher Instructions
The matrix switcher accepts SIS (Simple Instruction Set) commands through the rear panel
Remote RS-232/RS-422 port, the front panel Configuration port, and the rear panel Ethernet
(LAN) Port. SIS commands consist of one or more characters per command field. They do not
require any special characters to begin or end the command character sequence. Each matrix
switcher response to an SIS command ends with a carriage return and a line feed (CR/LF =
which signals the end of the response character string. A string is one or more characters.
Matrix-Switcher-Initiated Messages
When a local event such as a front panel operation occurs, the matrix switcher responds
by sending a message to the host. The matrix switcher-initiated messages are listed below
(underlined).
The matrix switcher does not expect a response from the host, but, for example, the host
program might request a new status.
(c) Copyright 20yy, Extron Electronics, XTP CP nn00, Vx.xx, 60-nnnn-01
<day, date, time>
The matrix switcher initiates the
connection via Internet protocol (IP) is established.
60-nnnn-01
NOTE:
Password:
The matrix switcher initiates the
when the controlling system is connected using TCP/IP or Telnet and the matrix switcher is
password protected. This message means that the matrix switcher requires an administrator
or user level password before it will perform the commands entered via this link. The matrix
switcher repeats the password message response for every entry other than a valid password
until a valid password is entered.
]
]
The matrix switcher initiates the
has been entered. If the user and administrator passwords are the same, the matrix switcher
defaults to administrator privileges.
Qik
The matrix switcher initiates the
PrstSnn
The matrix switcher initiates the
the front panel. "
PrstRnn
The matrix switcher initiates the
the front panel. "
Innn
The matrix switcher initiates the
occurred. "
]
is the matrix switcher part number.
<day, date, time>
]
]
Login Administrator
]
Login User
]
]
" is the preset number.
nn
]
" is the preset number.
nn
]
•
Audxx
" is the input number and "
n
message when it is first powered on or when a
Copyright
is the firmware version number and
Vx.xx
are reported only if the connection is via the LAN port.
message immediately after the copyright message
Password
message when a correct administrator or user password
Login
message when a front panel tie creation has occurred.
Qik
message when a memory preset has been saved from
PrstS
message when a memory preset has been recalled from
PrstR
message when a front panel input audio level change has
Aud
" is the dB level.
xx
XTP CrossPoint Series • Programming Guide
]
),
]
79
Advertisement
Table of Contents
