Control Tab; Set And View Ties Page - Extron electronics XTP CrossPoint1600 User Manual

Control Tab

Set and View Ties Page

You can create ties on the
by clicking the
Figure 68.
The page consists of a matrix of input (rows) and output (columns) selection buttons of four
different colors:
•
•
•
•
The page displays only those inputs and outputs that are available on installed boards only.
Select and switch an input as follows:
1.
2.
3.
Set and View Ties
tab (see figure 68,
Control
1 1
2 2
User Control Ties page
Amber buttons indicate video and audio ties.
Green buttons indicate video only ties.
Red buttons indicate audio only ties.
Gray buttons indicate no ties.
Click the ,
Video Only Audio Only
audio, or both for switching (audio follow or audio breakaway). Each mouse click on a
button toggles the other two buttons off.
Move the mouse over the matrix of input and output buttons (
a pending tie (if a tie does not exist) or pending untie (if a tie exists) of the input and output
associated with that button. A "
NOTES:
•
If you lose track of the input and output associated with a specific button, let the
mouse rest over one of the tie buttons for a moment. A field pops up (as shown
on figure 68) that identifies the input and output for that button.
• To tie an input to all outputs, click that input number.
Click the button ( ) to make the configuration changes or the
4
Take
abandon the configuration changes.
page. Access the
).
1
4 4
3 3
, or
Video & Audio
" (for pending) appears in the button.
P
XTP CrossPoint Series • HTML Operation
Set and View Ties
button ( ) to select video,
2
). Click a button to create
3
button to
Cancel
page
137