Programming Guide - Extron electronics XTP II CrossPoint 1600 User Manual

Programming
Guide
The XTP II CrossPoint Matrix Switcher can be remotely controlled via:
•
•
•
This section describes the operation of the XTP II CrossPoint Matrix Switchers via SIS
commands, including:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
The XTP System Configuration software (see the XTP System Configuration Software
help file, available at www.extron.com).
Built-in HMTL pages (see HTML
SIS commands (see below)
Local Host-Control Ports
Ethernet (LAN) Port
Host-to-Switcher Instructions
Switcher-Initiated Messages
Switcher Error Responses
Using the Command and Response Tables
SIS Command and Response Table for Basic Matrix Switcher Commands
SIS Command and Response Table for Input-Board-Specific Commands
SIS Command and Response Table for Input-Endpoint-Specific Commands
SIS Command and Response Table for Output-Board-Specific Commands
SIS Command and Response Table for Output-Endpoint-Specific Commands
SIS Command and Response Table for Advanced Matrix Switcher
Commands
SIS Command and Response Table for IP- and Remote Port-Specific
Commands
Special Characters
XTP II CrossPoint 1600, 3200, and 6400 Switchers • Programming Guide
Operation, beginning on page 119)
76