Features - Extron electronics XTP CrossPoint1600 User Manual

Secondary signal type
Serial port inserts
The XTP and fiber input and output boards also have four local RS-232 and IR insert inputs
on captive screw connectors. The insert inputs support up to a 115k baud rate. Each
RS-232 and IR insert and local output is for the associated input or output only and cannot
be tied to other outputs or inputs.
Dedicated UARTs — Ethernet insertion
The XTP CrossPoint Series matrix switcher can send control signals to inputs and outputs
on the XTP and fiber input and output boards using dedicated UART ports. Each XTP and
fiber input and output has a dedicated UART port to allow bidirectional communication on
every XTP port simultaneously. Once the Ethernet-to-RS-232 feature is enabled, via the XTP
Configuration Software or an SIS command, the XTP input or output is unable to pass any
RS-232 commands from the local insert connections on the I/O board but instead passes
the communications via the UART.
Analog audio inputs
Boards listed in the
audio input captive screw connectors for balanced or unbalanced 2-channel audio. These
boards can perform analog-to-digital conversion of analog audio inputs for audio breakaway
ties. Analog audio input levels can be adjusted through a range of +24 dB gain through
–18 dB attenuation.
Analog audio outputs
Boards listed in the
captive screw connectors for balanced or unbalanced 2-channel audio. These boards
extract 2-channel audio from the embedded stream for analog audio outputs with mute and
audio volume controls.

Features

•
•
•
•
•
•
table on page 4 as supporting analog audio input have four stereo
table as supporting analog audio output have four stereo audio output
Available in I/O sizes from 4x4 to 32x32 — System configuration is flexible to match
a wide variety of small to large-sized installations.
15.2 Gbps data-rate digital backplane — Ensures switching and distribution of
video signals without degradation, offering the performance required to maintain signal
integrity with the most demanding high resolution signals.
Compatible with all XTP integrated system products — XTP CrossPoint Series is
a flexible, reliable signal switching and distribution system that provides a completely
integrated solution for multiple digital and analog formats.
Fully digital signal routing — Analog signals are digitized, sending a reliable, high
quality digital video signal to the output destination.
Wide selection of input and output boards — Boards provide integration for a
variety of signal types and formats, ensuring system customization appropriate for a
wide range of applications.
Serial port insertion from the Ethernet control port — System level device
control to all remote locations via the Ethernet port of the matrix switcher, providing
comprehensive control of endpoints and attached devices without needing additional
cabling.
XTP CrossPoint Series • Introduction 7