Table of Contents
Advertisement
Outnn
The matrix switcher initiates the
change has occurred.
Vmtnn*x
The matrix switcher initiates the
off from the front panel.
Amtnn*x
The matrix switcher initiates the
off from the front panel.
Execn
The matrix switcher initiates the
(Executive mode) is switched from the front panel. "
Matrix Switcher Error Responses
When the matrix switcher receives an SIS command and determines that it is valid, it
performs the command and sends a response to the host device. If the matrix switcher
is unable to perform the command because the command is invalid or contains invalid
parameters, the matrix switcher returns an error response to the host. The error response
codes are:
E01
E10
E11
E12
E13
E14
E17
E22
E24
E25
E26
E27
E28
Using the Command and Response Tables
The
represent variables in the command and response fields. Command and response examples
are shown throughout the tables. With the exception of the audio input gain and attenuation
commands, the SIS commands are not case sensitive. The ASCII to HEX conversion table
below is for use with the command and response table.
Space
]
•
Volxx
is the output number and
nn
]
is the output number and
nn
]
is the output number and
nn
]
— Invalid input channel number (out of range)
— Invalid command
— Invalid preset number (out of range)
— Invalid output number (out of range)
— Invalid value (out of range)
— Invalid command for this configuration
— Timeout (caused only by direct write of global presets)
— Busy
— Privileges violation (Users have access to all view and read commands [other than
the administrator password], and can create ties, presets, and audio mutes
— Device not present
— Maximum number of connections exceeded
— Invalid event number
— Bad filename / file not found
command and response tables
ASCII to Hex Conversion Table
message when a front panel output audio volume
Vol
is the volume level.
xx
message when an output video mute is toggled on or
Vmt
is the mute status:
x
message when an output audio mute is toggled on or
Amt
is the mute status:
x
message when the front panel security lockout
Exec
" is the Executive mode:
n
begin on page 87. Symbols used in the tables
•
XTP CrossPoint Series • Programming Guide
= on,
= off.
1
0
= on,
= off.
1
0
,
, or
.
0
1
2
80
Advertisement
Table of Contents
