Extron electronics XTP CrossPoint1600 User Manual page 65

Xtp crosspoint series configurable digital video matrix switchers
Table of Contents

Advertisement

Example 9: Viewing and adjusting an analog output volume level
In the following example, the audio output volume is viewed and adjusted. The steps show
the front panel indications that result from your action.
Because of the different volume display schemes, the output audio levels that result from the
following example are shown twice:
As displayed on an XTP CrossPoint 3200 matrix switcher
As displayed on an XTP CrossPoint 1600 matrix switcher
The XTP CrossPoint 3200 drawings show the actions that led up to the display.
The XTP CrossPoint 1600 drawing shows the volume display only, not the actions that
caused it.
1.
Clear all selections: Press and release the
2.
Select Audio mode: Press and hold the
until it blinks.
Press and hold.
AUDIO
2 seconds
3.
Select an output: Press and release the
In figure 40 and figure 41, the lit or blinking input buttons indicate 41.5 percent of the
applied audio input. The unlit input buttons indicate an audio volume attenuation of
39 dB.
2 16
1
Press to light
the button.
Each lit input button beyond input 1 indicates that 3 percent of the total input volume
is applied to the output. The flashing button indicates an additional 1.5 percent.
Figure 40.
Select Output 1
Figure 41 shows the same volume as figure 40, but displayed on an
XTP CrossPoint 1600.
2
1
3
4
5
Figure 41.
Volume Display on an XTP CrossPoint 1600 Matrix Switcher
NOTE: Volume is protected when front panel Lock mode 2 is selected. You can
view the volume in Lock mode 2 but you cannot change it from the front panel
(see
Setting the Front Panel Locks (Executive Modes)
If front panel Lock mode 2 is selected and you try to perform step 4, the actions
are ignored and the
button.
Esc
button for approximately 2 seconds
Audio
AUDIO
Output 1
2
1
3
17 18 19 27 28 29 30 31 32
39 dB attenuation,
41.5% volume
INPUTS
6
7
8
9 10 11 12
,
, and
buttons blink.
Enter
Video
Audio
XTP CrossPoint Series • Operation
button (see figure 38).
39 dB attenuation
41.5% volume
INPUTS
1 12 13 14 15 16
13
14 15 16
on page 59).
57

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xtp crosspoint 3200

Table of Contents