Creating A Configuration - Extron electronics CrossPoint 300 Series User Manual

im Vertrieb von
Operation, cont'd

Creating a configuration

The current configuration can be changed using the front panel buttons.
Change the current configuration as follows:
1.
2.
3.
4.
5.
www.camboard.de
3-8 CrossPoint 300 Matrix Switchers • Operation
CAMBOARD Electronics
Press the Esc button to clear any input LEDs, output LEDs, or control LEDs
that are lit.
Select to configure video, audio, or both by pressing the RGBHV button
and/or Audio button.
Select the desired input and output(s) by pressing the input and output
buttons.
To indicate potential ties, output LEDs blink when an output is selected but
not tied to the input.
To indicate current ties, output LEDs light steadily when an input is tied to
the output.
To clear unwanted outputs, press and release the output buttons associated
with the lit LEDs. To indicate potential unties, output LEDs blink when an
output is deselected but not untied from the input.
Press and release the Enter button to accept the new tie or to break an existing
tie.
Repeat steps 1 through 4 to create additional ties until the desired
configuration is complete.
• Only one video input and one audio input can be tied to an output.
• If a tie is made between an input and an output, and the selected output
was previously tied to another input, the older tie is broken in favor of the
newer tie.
• To indicate current ties, output LEDs light when an input is selected. To
clear unwanted outputs, press and release the associated output buttons.
• If, when configuring video and audio ties, the Audio LED blinks and the
RGBHV LED is on after selecting an input or output, the LEDs indicate
audio breakaway, meaning that the audio ties are not the same as the video
ties for that input.
• If an input with no tie is selected, only that input's LED lights.
• When the RGBHV and Audio LEDs are on, if an input with an audio tie
but no video tie is selected, the input's LED lights and the Audio LED
blinks.
• As each output is selected, the associated output LED blinks to indicate a
tentative tie. LEDs for output(s) that were already tied to the input light
steadily. Outputs that are already tied can be left on, along with new
blinking selections, or toggled off by pressing the associated output
button.
Tel. 07131 911201
Fax 07131 911203
ce-info@camboard.de