Powering On; Creating A Configuration - Extron electronics DXP DVI Pro User Manual

Powering On

and to an AC source. The switcher performs a self-test that flashes the front panel
button indicators red, green, and amber and then turns them off. An error-free power-up
self-test sequence leaves all I/O and control buttons either unlit or showing background
was when the switcher was previously powered off.
power is applied, the most recent configuration is retrieved. The previous presets remain
intact.
If an error occurs during the self-test, the DXP locks up and does not operate. If this
information

Creating a Configuration

A configuration consists of one or more inputs, each tied to a set of one or more outputs.
NOTE:
This section contains the steps to follow to create or change a configuration. The following
subsections contain some examples of configurations that can be created on the DXP,
and instructions for setting them up. The illustrations show the DXP 88; however, the
procedures apply to all DXP models.
To create a configuration:
1.
2.
3.
in your area).
one input.
>
button to clear any input, output, or control button indicators that
may be lit.
Select to configure video, audio, or both by pressing the
h
Select the desired input and outputs by pressing the input and output buttons
a b
( and in figure 10).
The input buttons light one of the following colors:
Amber:
Green:
Red: Audio only ties
Output buttons light or blink one of the following colors:
Amber:
Green:
Red: Audio only ties
To indicate potential ties, output buttons blink in the appropriate color when an
input is selected.
To indicate current ties, output buttons light steadily in the appropriate color
when an input is selected.
To clear unwanted outputs, press and release the associated lit output buttons. To
indicate potential unties, output buttons blink the appropriate color when an
output is deselected (muted) but not untied from the input.
i
and in figure 10).
contact
18