Ping Test; Ipv4 Ping Test - D-Link xStack DGS-3400 Series Reference Manual

x Stack

Ping Test

Ping is a small program that sends ICMP Echo packets to the IP address you specify. The destination node then responds to or
"echoes" the packets sent from the Switch. This is very useful to verify connectivity between the Switch and other nodes on the
network.

IPv4 Ping Test

The following window is used to Ping an IPv4 address.
To view this window, click Administration > Ping Test > IPv4 Ping Test as shown below.
The following parameters can be configured:
Parameter Description
Target IP Click the radio button and enter the Target IP Address to be pinged.
Address
Domain Name Click the radio button and enter the domain name of the host.
Repeat Times The user may use the Infinite times radio button, in the Repeat Pinging for field, which will tell
the ping program to keep sending ICMP Echo packets to the specified IP address until the
program is stopped. The user may opt to choose a specific number of times to ping the Target IP
Address by clicking its radio button and entering a number between 1 and 255.
Timeout Select a timeout period between 1 and 99 seconds for this Ping message to reach its destination.
Source IP
Tick the check box and enter the source IP address of the ping packets.
Address
Click Start to initiate the Ping program.
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 52 IPv4 Ping Test window
59