System > Telnet Settings; System > D-Link Discover Protocol Settings; System > Ping Test - D-Link DSG-1100-10/ME Manual

D-Link DGS-1100-10/ME User Manual
Figure 4.33– System > Web Settings
Port (1-65535): Specifies the Port number. The range is between 1 and 65535 with the well-known default is
80.
System > Telnet Settings
Telnet configuration is Enabled by default. If you do not want to allow Telnet configuration, then select
Disabled.
Figure 4.34 – System > Telnet Settings
Port (1-65535): The TCP port number. TCP ports are numbered between 1 and 65535. The well-known TCP
port for the Telnet protocol is 23.
System > D-Link Discover Protocol Settings
For the D-Link Discovery Protocol (DDP) supported device, this page is an option for you to disable DDP or
configure the DDP packet report timer.
Figure 4.35 – System > D-Link Discover Protocol Settings
D-Link Discover Protocol State: Enable or disable the Discover Protocol state.
D-Link Discover Protocol Report Timer (Seconds): Configure the report timer of D-Link Discover Protocol
in seconds. The values are 30, 60, 90, 120 or Never.
Click Apply for the changes to take effect.
System > Ping Test
You can Ping either an IPv4 address or an IPv6 address. Ping is a small program that sends ICMP Echo
packets to the IP address you specify. The destination node then responds to or "echoes" the packets sent
from the Switch. This is very useful to verify connectivity between the Switch and other nodes on the network.
2 2 9 9