D-Link xStack DGS-3400 Series Reference Manual page 130

x Stack
The following parameters can be configured:
Parameter
Unit
From /To
State
Priority
®
DGS-3400 Series Layer 2 Gigabit Ethernet M anaged Sw itch
Figure 2 - 134 PoE Port Settings window
Description
Choose the switch in the switch stack for which to configure the PoE settings.
Users should note that not all switches in the xStack
when they are configured in a stack, the Primary Master switch will display the PoE settings to
be configured for the stack, whether or not the Switch is a PoE supported device. However,
only PoE supported switches have the PoE capability in the switch stack.
Select a range of ports from the pull-down menus to be enabled or disabled for PoE.
Use the pull-down menu to enable or disable ports for PoE.
Use the pull-down menu to select the priority of the PoE ports. Port priority determines the
priority which the system attempts to supply the power to the ports. There are three levels of
priority that can be selected, Critical, High, and Low. When multiple ports happen to have the
same level of priority, the port ID will be used to determine the priority. The lower port ID has
®
DGS-3400 series support PoE yet,
117